SmartWare Software Configuration Guide
Introduction
The SIP profile specifies disconnect cause mappings from SIP codes to Q.931 causes, and vice versa. As for all
profiles, there is a default profile at system startup that can be modified. Only those causes that differ from the
default mapping have to be configured. If a new profile is created, all mappings are set to their default and are
only overwritten if configured. The default mapping in both directions is according to RFC3398 - ISUP to SIP
Mapping.
A SIP profile can either be attached to SIP interfaces or to identities. To see how to configure a SIP profile for
an interface, see Chapter 39,
configuration for identities, see Chapter 51,
SIP profile configuration task list
This section describes the configuration tasks for SIP profile listed below.
•
Enter the configuration mode for a SIP profile (see
•
Map from a SIP disconnect cause to a Q.931 cause (see
•
Map to a SIP cause from a Q.931 disconnect cause (see
•
Map from a SIP redirection code to a Q.931 redirect reason (see
•
Map to a SIP redirection code from a Q.931 redirect reason (see
Entering the configuration mode for a SIP profile
The profile sip command enters the configuration mode of an existing profile or creates a new one with a spec-
ified name. It also destroys an existing profile except the default, which always exists.
Mode: Configure
Step
1
[name](cfg)#[no] profile name <name>
Mapping from a SIP disconnect cause
The map cause from-sip command maps a specific SIP disconnect cause to a Q.931 cause used by the call con-
trol. All causes are pre-defined in the system and are provided by the command.
Mode: Profile SIP
Step
1
[name](pf-sip)[name]#map cause from-
sip sip-cause to q931-cause
Introduction
"SIP interface configuration"
"Location Service"
Command
Command
49 • SIP profile configuration
on page 436. For information about SIP profile
on page 602.
page
597)
page
597)
page
598)
page
598)
page
598)
Creates/Destroys a SIP profile or enter the con-
figuration mode of an existing one.
Maps a specific SIP disconnect cause to a
Q.931 cause.
Purpose
Purpose
597