Binding And Unbinding An Access Control List Profile To An Ip Interface - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
Binding and unbinding an access control list profile to an IP interface
The command use is used to bind an access control list profile to an IP interface. This procedure describes how
to bind an access control list profile to incoming packets on an IP interface
Mode: Profile access control list
Step
1 node(if-ip)[if-name]#use profile acl name in
Where the syntax is:
Keyword
if-name The name of the IP interface to which an access control list profile gets bound
name The name of an access control list profile that has already been created using the profile acl
command. This argument must be omitted in the no form
in Specifies that the access control list profile applies to incoming packets on this interface.
out Specifies that the access control list applies to outgoing packets on this interface.
The form of the
no use
using this form the name of an access control list profile, represented by the name argument above, is not
required. This procedure describes how to unbind an access control list profile to incoming packets on an IP
interface
Mode: Interface
Step
1 node(if-ip)[if-name]#no use profile acl in
Where the syntax is:
Keyword
if-name The name of the IP interface to which an access control list profile gets bound
in Specifies that the access control list profile applies to incoming packets on this interface.
out Specifies that the access control list applies to outgoing packets on this interface.
Thus for each IP interface only one incoming and outgoing access control list can be active at the same time.
Example: Bind and unbind an access control list entries to an IP interface
Bind an access control list profile to incoming packets on the interface wan in the IP router context.
node(cfg)#context ip router
node(cfg-ip)[router]#interface wan
node(cfg-if)[wan]#use profile acl WanRx in
Access control list configuration task list
Command
command is used to unbind an access control list profile from an interface. When
Command
24 • Access control list configuration
Binds access control list profile name to incom-
ing packets on IP interface if-name
Meaning
Purpose
Unbinds access control list profile for incoming pack-
ets on IP interface if-name
Meaning
Purpose
261