Copying Configurations Within The Local Memory; Local Memory Regions - Patton electronics SmartNode Series Software Configuration Manual

SmartWare Software Configuration Guide
• Copying configurations within the local memory (see
• Replacing the startup configuration with a configuration from the Flash memory (see
• Copying configurations to and from a remote storing location (see
• Replacing the startup configuration with a configuration downloaded from the TFTP server (see
• Displaying configuration file information (see
• Modifying the running configuration at the CLI (see
• Modifying the running configuration offline (see
• Deleting a specified configuration (see
• Downloading encrypted files (see
Copying configurations within the local memory
Configuration files may be copied into the local memory in order to switch between different configurations.
Remember the different local memory regions in SmartWare as shown in

Local Memory Regions

Copy Configuration Files within
the persistent Memory Region
In most cases, the interactively modified running configuration known as the running-config, which is located
in the volatile memory region system:, is copied into the persistent memory region nvram:. This running config
is stored under the name startup-config and replaces the existing startup configuration.
Configuration file handling task list
page
page 82)
page
page 84)
page 85)
page 86)
Local
Persistent
nvram:
• Factory
Configuration
"factory-config"
(read-only)
• Startup
Configuration
"startup-config"
• User specific
Configuration
"user-config"
Figure 11. Local memory regions
6 • Configuration file handling
79)
page 81)
83)
figure 11.
Store the current Running
Configuration persistently
Volatile
system:
• current Running
Configuration
"running-config"
Only on Startup to execute
the Startup or Factory
Configuration
page 80)
page 82)
79