Honda S2000 Service Manual page 599

5. Remove the flange bolts {A). and the upper arm.
1 2 x 1 . 2 5 m m
103 N.m (10,5 kgt.m, 75.9lbt.ftl
I n s t a l l t h e u p p e r a r m i n t h e r e v e r s e o r d e r o f
removal paying particular attention to the following
items:
Be careful not to damage the ball joint boot when
connecting the upper arm to the knuckle.
Tighten all mounting hardware to the specified
t o r q u e v a l u e s ,
First install allthe susDension comoonents and
lightly tighten bolts and a nut, then place a jack
under the lower arm, and raise the suspension to
load the weight before fully tightening to the
sDecified toroue values.
Tighten the castle nut to the lower torque
specification, then tighten only far enough to
a l i g n t h e s l o t w i t h t h e b a l l j o i n t p i n h o l e . D o n o t
align by loosening the castle nut.
lnstall a new lock Din on the castle nut after
t o r q u i n g .
Before installing the wheel, clean the mating
s u r f a c e o f t h e b r a k e d i s c a n d t h e i n s i d e o f t h e
w h e e l .
C h e c k t h e w h e e l a l i g n m e n t , a n d a d j u s t i t i f
necessary (see page 18-5).
18-21