Honda S2000 Service Manual page 114

1 8 . I n s t a l l t h e e l e c t r i c a l p o w e r s t e e r i n g ( E P S ) c o n t r o l
unit.
6 x 1 . 0 m m
12 N.m (1.2 kgf.m,8.7 lbf.ft)
1 9 . I n s t a l l t h e v a c u u m t a n k .
6 x 1 . 0 m m
1 2 N . m
(1.2 kgf.m,8.7 lbf.ftl
,R
l)
,
20. Install the throttle cable (see page 11-125), then
a d j u s t t h e c a b l e ( s e e p a g e 1 1 - 1 2 4 ) .
2 1 . I n s t a l l t h e t r a n s m i s i o n ( s e e p a g e 1 3 - 6 6 ) .
22. Clean the battery posts and cable terminals with
sandpaper, then assemble them and apply grease
to prevent corrosion.
2 3 . R e f i l l t h e e n g i n e w i t h e n g i n e o i l ( s e e p a g e 8 - 5 ) .
24. Refillthe radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open (see page 10-8).
25. Check that the transmission shifts into gear
smoothly.
26. lnspect for fuel leaks. Turn the ignition switch ON
(ll) (do not operate the starter) so that the fuel pump
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation two or three times, then
check for fuel leakage at any point in the fuel line.
27. Perform the engine control module (ECM) idle learn
p r o c e d u r e ( s e e p a g e 1 1 - 1 0 0 ) .
2 8 . I n s p e c t t h e i d l e s p e e d ( s e e p a g e 1 ' l - 1 0 0 ) .
29. Inspect the ignition timing (see page 4- 18).
30. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
3 1 . S e t t h e c l o c k .
5 - 1 1