Lower Arm Removal/Installation - Honda S2000 Service Manual

Lower Arm Removal/lnstallation
Special Tools Required
. Ball joint remover, 28 mm 07MAC-S100200
1. Raise the front of the vehicle, and support it with
safety stands in the proper locaions {see page 1-13).
Remove the front wheel.
2. Remove lhe flange nut (A) while holding the joint
pin (B) with a hex wrench (C), and disconnect the
s t a b i l i z e r l i n k ( D ) f r o m t h e l o w e r a r m ( E ) .
A
10 x 1.25 mm
29 N m (3.0 kgf.m, 22 lbf.ft)
3 .
Remove the flange bolt (A), and disconnect the
d a m p e r ( B ) f r o m t h e l o w e r a r m ( C )
10 x 1.25 mm
6 4 N m
(6.5 kgf.m, 47 lbf.ft)
4. Remove the cotter pin (A)from the lower arm ball
ioint, and remove the castle nut (B).
Remove the lower arm ball joint from the knuckle
using the special tool (see page 18-10).
Remove the self-locking nut (A) and self-locking
cam nut (B). then remove the cam plate {C).
adjusting bolt (D), cam collar (E), flange bolt (F),
and the lower arm.
5 .
6 .
12 x 1.25 fim
78 N.m (8.0 kgf.m,58lbf.ft)
B
12 x'l.25 nm
78 N.m
{8.0 kgf rn, 58 lbf.ft}
(cont'd)
1 8 - 1 9