EPS Components
DTG Troubleshooting (cont'd)
DTC 14: Torque Sensor (Resistance)
1 . C l e a r t h e D T C .
2. Sta rt the engine.
3. Turn the steering wheelfully to the left, and hold it
in that position for 10 seconds or more.
Does the EPS indicator come on?
YES Go to step 4.
NO Check for loose wires or poor connections. lf
the connections are good, the system is OK at this
t i m e . l
4. Stop the engine, and verify the DTC.
ls DTC 14 indicated?
YES- Go to step 5.
NO- Perform the appropriate troubleshooting for
the code indicated.l
5. Make sure the ignition switch is OFF, then
disconnect the torque sensor 3P connector and EPS
control unit connector B (14P).
6. Check for continuity between torque sensor 3P
c o n n e c t o r t e r m i n a l s N o , 1 a n d N o . 2 .
TOROUE SENSOR 3P
CONNECTOR
Terminal side of {emale terminals
ls there continuity?
YES Repair short between the BLU/RED and PNK
wires in the torque sensor circuit between the
torque sensor and the EPS control unit.l
NO Go to step 7.
17-34
7, Check for continuity between torque sensor 3P
c o n n e c t o r t e r m i n a l s N o . 2 a n d N o . 3 .
TOROUE SENSOR 3P
CONNECTOR
(BLU/RED}
lerminal side of female terminals
ls there continuity?
YES Repair short between the WHT/GRN and
BLU/RED wires in the torque sensor circuit between
the torque sensor and the EPS control unit.l
NO Go to step 8.
Check for continuity between torque sensor 3P
c o n n e c t o r t e r m i n a l s N o . 1 a n d N o . 3 .
TOROUE SENSOR 3P
CONNECTOR
vs2
(wHT/GRN)
Terminal side ol lemale terminals
ls there continuity?
YES Repair short between the WHT/GRN and PNK
wires in the torque sensor circuit between the
torque sensor and the EPS control unit.l
NO Go to step L
8 .