3t-'r
.. :r
sRs
DTC Troubleshooting (cont'd)
DTC 4-5: Short to Ground in Passenger's Seat
Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-T8401 1A
. SRS simulator lead C 07TM-S25011A
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO- Intermiftent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the passenger's seat belt tensioner 2P
connector from the SRS main harness (A).
Az-SZs011A
\orro.-rrnorro
Connect the SRS inflator simulator (2 Q connector)
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n h a r n e s s .
23-52
T L
f , \
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 4-5 indicated?
YES- Go to step 9.
NO - Short to ground in the passenger's seat belt
tensioner; replace the passenger's seat belt (see
page 23-4).1
9. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
\