Blower/Evaporator Unit Components Replacement - Honda S2000 Service Manual

Blower/Evaporator Unit Components Replacement
Note these items when overhauling the blower/evaporator unit:
. The recirculation control motor (A), the powertransistor (B), and the blower motor (C)can be replaced without
removing the blower/evaporator unit.
. l f y o u ' r e i n s t a l l i n g a n e w e v a p o r a t o r c o r e ( D ) , a d d r e f r i g e r a n t o i l
( K E I H I N S P - 1 0 ) ( s e e p a g e 2 l - 6 ) .
. lf necessarV, removethe expansion valve (E).
. R e p l a c e t h e O - r i n g s w i t h n e w o n e s a t e a c h f i t t i n g a n d a p p l y a t h i n c o a t o f r e f r i g e r a n t o i l b e f o r e i n s t a l l i n g t h e m .
Be sure to use the correct O-rings for HFC-134a {R-134a) to avoid leakage.
. lmmediately after using the oil. reinstallthe cap on the container, and seal it to avoid moistu re absorption.
. Reinstall the eva porator tem peratu re senso r (F) in its original location.
. Before reassembly, make surethatthe recirculation control linkage and doors move smoothly.
. After reassembly, makesurethe recirculation control motor runs smoothly (see page 21-35).
. Make sure no air is leaking from the upper housing {G) and the lower housing (H) fitting.
21-39