Honda S2000 Service Manual page 609

'16.
Remove the lock pin (A) from the upper arm ball
joint, and remove the castle nut (B).
1 7 .
1 8 .
B
1 2 x ' 1 , 2 5 m r n
49-59 N.m
{5.0-6.0 kgf.m, 36-iB lbt ft}
Remove the upper arm ball joint from the knuckle
u s i n g t h e s p e c i a l t o o l ( s e e p a S e ' 1 8 - 1 0 ) .
Remove the driveshaft outboard joint {A) from the
knuckle by tapping the driveshaft end with a plastic
h a m m e r ( B ) w h i l e p u l l i n g t h e k n u c k l e ( C ) o u t w a r d .
-
-.._..,,:.
r,...'\
.;z +':.
.,.
t-
';l '.-
)
20.
19. Separate the hub (A)from the knuckle (B) using the
special tool and a hydraulic press. Be careful notto
deform the splash guard. Hold the hub to keep it
from falling when pressed clear.
Remove the screws (A), snap ring (B), and the
s p l a s h g u a r d ( C ) f r o m t h e k n u c k l e ( D ) .
(cont'd)
18-31