Table of Contents
Advertisement
Engine Block
Pulley End Crankshaft Seal
Installation - In Car
Special Tools Required
' Seal driver 07LAD-PT3o10A
1. Dry the crankshaft oil seal housing.
2. Using the seal driver, drive in the crankshaft oil seal
until the driver bottoms against the chain case,
07LAD.PT3OlOA
7-26
Transmission End Crankshaft Seal
lnstallation - In Car
Special Tools Required
. Driver 07749-0010000
. Driver attachment 07948-S800101
1. Dry the crankshaft oil seal housing.
2, Use the specialtools to drive a new oil seal
squarely into the block to the specified installed
height.
079it8-S800101
Measure the distance between the crankshaft {A)
a n d o i l s e a l { B ) .
Oil Saal Installed Height:
5.5-6.5 mm 10.22 0.26 in.l
{0.22*0.26 in.l
'.i.. "
- '..i
Advertisement
Table of Contents
Troubleshooting
