DTC 2-4: Short to Power in Passenger's
Airbag Inflator
Special Tools Required
. SRS inflator simulator 07SM-TB401'1A
. SRS simulator lead C 07TAZ-S25011A
1. Erase the DTC memory {see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the passenger's airbag 2p connector
f r o m t h e S R S m a i n h a r n e s s 1 A ) .
5. Connect the SRS inflator simulator (2 e conneclor)
and the simulator lead to the SRS main harness.
6. Reconnecl the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 2-4 indicated?
YES Go to step 9.
NO Short to power in the passenger's airbag;
replace the passenger's airbag (see page 23-67). t
9. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
10. Djsconnect the driver's airbag 2P connector (A) and
both seat belt tensioner (B).