Propeller Shaft Inspection - Honda S2000 Service Manual

Driveline/Axle
Driveshafts Installation (cont'dl
Install a new spindle nut (A), then tighten the nut.
After tightening, use a drift to stake the spindle nut
shoulder (B) against the driveshaft.
A
1 2 x 1 . 5 m m
24 x 1.5 mm
108 N.m
245 N.m
(11.0 kgf.m,
(25.0kgt.m,
79.6lbl.ft)
'181 lbf.ftl
1 .
9 .
8 .
Clean the mating surfaces of the brake disc and the
rear wheel, then install the rear wheel with the
wheel nuts,
Turn the rear wheel by hand, and make sure the
clearance between the driveshaft and
circumference parts.
Check the rear wheel alignment, and adjust it if
necessary (see page 18-5).
1 6 - 1 6
Propeller Shaft Inspection
2 .
1 . Shift into neutrai position.
Raise the vehicle off the ground, and suppon it with
safety stands in the proper locations
(see page 1-'13).
Check the universal joint boots for damage and
deterioration. lf the boots are damaged or
deteriorated, replace the propeller shaft.
Check the joints for excessive play or rattle. lf the
universal joints have excessive play or rattle,
replace the propeller shaft.
5. lnstall a dial indicator (A) with its needleonthe
center of the propeller shaft (B).
6. Turn the propeller shaft slowly, and check the
runout. lf the runout exceeds the service limit,
replace the propeller shaft.
Runout:
Service Limit:
1.5 mm {0.06 in.l