sRs
DTG Troubleshooting (cont'd)
DTC 1-3: Short to Another Wire or Decreased
Resistance in Driver's Airbag Inflator
Special Tools Required
. s R s i n f l a t o r s i m u l a t o r 0 7 s A z - T B 4 o 1 1 A
. S R S s i m u l a t o r l e a d C 0 7 T M - S 2 5 0 1 1 A
'1.
Erase the DTC memory {see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-19).
Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag 2P connector from
the cable reel (A).
07TAZ-S25011A
Connect the SRS inflator simulator (2 Q connector)
and the simulator lead to the cable reel.
Reconnect the battery negative cable.
Erase the DTC memory.
6 .
1 .
23-26
8 .
Read the DTC.
ls DTC 1-3 indicated?
YES Go to step 9.
NO Short in the driver's airbag; replace the driver's
airbag (see page 23-65). !
Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the cable reel 2P connector from the
S R S m a i n h a r n e s s ( A ) .
07TAZ-S25011A
---.-----.._--.-
\
-.--------
-\N
\v
I t
,--'1,=ft'.fi
07sAz-TB4o'l'lA :
Connect the SRS inflator simulator (2 Q connector)
and the simulator lead to the SRS main harness.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC,
ls DTC 1-3 indicated?
YES Go to step
'15.
NO Shon in the cable reel; replace the cable reel
( s e e p a g e 2 3 - 7 2 ) . 1
9 .
1 0 .
{
't 1.
1 3 .
1 4 .