Honda S2000 Service Manual page 510

Special Tools Required
. Boot band tool, KD-3191 or equivalent, commercially
a v a i l a b l e
. Boot band pincers, Kent-Moore J-35910 or equivalent,
c o m m e r c i a l l y a v a i l a b l e
NOTE: Refer to the Exploded View as needed during
this orocedure.
Inboard Joint Side:
1. Wrap the splines with vinyl tape (A) to prevent
damage to the inboard boot.
lnstall the inboard boot to the driveshaft, then
remove the vinyl tape. Be careful not to damage the
inboard boot.
Install the spider (A) onto the driveshaft (B) by
a l i g n i n g t h e m a r k s ( C ) o n t h e s p i d e r a n d t h e e n d o f
the driveshaft.
Fit the circlip (D) into the driveshaft groove. Always
rotate the circlip in its groove to make sure it is fully
seated.
5. Fit the rollers (A) onto the spider (B) asshown,and
note these items;
. Reinstall the rollers in their original positionson
the spider by aligning the marks (C).
. Hold the driveshaft pointed up to prevent the
rollers from falling off.
Pack the inboard joint with the joint grease
included in the new driveshaft set.
Grease quantily
Inboardioint: 150- 160 g (5.3 5.6 oz)
6 .
l J s e t h e
. . ?-r=.r? l- .-__--
u s e t n e g r e a s e I n c i u o e o
i
i n t h e i n b o a r d b o o r s e l .
I
(cont'd)
16-9