Dtc 5-1 - 9-2: Internal Failure Of The Srs Unit; Dtc 10-1: Airbags And/Or Seat Belt Tensioners Deployed - Honda S2000 Service Manual

sRs
DTG Troubleshooting (cont'd)
DTC 5-1, 5-2, 5-3, 5-4, 6-1, 6-2, 6-3, 6-4,7-1,7 -2,
7-3,8-1,8-2,8-3, 8-4, 8-6, 9-1, 9-2: Internal
Failure of the SRS Unit
NOTE: Before troubleshooting any of these DTCs, check
the battery/system voltage. lf the voltage is Iow, repair
the charging system before troubleshooting the SRS. lf
the battery/system voltage is now OK, ask the customer
if the battery ever went dead.
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES - Replace the SRS unit (see page 23-75).I
NO- lntermittent failure, system is OK at this time.
Go to Troubleshooting lntermittent failures (see
p a g e 2 3 - 1 9 ) .
23-54
DTC 10-1: Airbags and/or Seat Belt
Tensioners Deployed
The SRS unit must be replaced after any airbags and/or
tensioners have deployed (see page 23-75).