sRs
DTC Troubleshooting (cont'dl
DTC 2-1: Open in Passenger's Airbag lnflator
DTC 2-2: Increased Resistance in Passenger's
Airbag Inflator
SpecialTools Required
. SRS inflator simulator 07SAZ-T840'l1A
. S R S s i m u l a t o r l e a d C 0 7 T M ' S 2 5 0 1 1 A
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
S R S i n d i c a t o r l i g h t c o m e s o n f o r a b o u t 6 s e c o n d s
and then goes off.
Doesthe SRS indicator light stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the passenger's airbag 2P connector
f r o m t h e S R S m a i n h a r n e s s ( A ) .
C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 Q c o n n e c t o r )
a n d t h e s i m u l a t o r i e a d t o t h e S R S m a i n h a r n e s s .
5 .
23-32
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 2-1 or 2-2 indicated?
YES Go to step 9.
NO Open or increased resistance in the
passenger's airbag; replace the passenger's airbag
(see page 23-67).I
9. Turn the ignition switch OFF, then disconnectthe
battery negative cable, and wait for 3 minutes.
1 0 . D i s c o n n e c t t h e d r i v e r ' s a i r b a g 2 P c o n n e c t o r ( A ) a n d
both seat belt tensioner 2P connectors (B).
\|