Gauges
Vehicle Speed Signal Circult
Troubleshooting (cont'dl
Reconnect the VSS 3P connector, and put the car in
neutral with the ignition switch ON (ll).
Slowly rotate the propeller shaft.
Measure voltage betr,/veen the gauge assembly
connector C (20P) No. 3 terminal and body ground.
GAUGE ASSEMBLY CONNECTOB C {2OP}
Does voltage pulse trcm 0 to approx. 5 V?
YES Check connections, and if necessary, replace
the printed circuit board.l
NO Go to step 9.
Turn the ignition switch OFF.
Disconnect the 3P connector from the vehicle
speed sensor lVSS).
T u r n t h e i g n i t i o n s w i t c h O N ( l l ) .
Measure the voltage between the vss 3P
connector No.2 terminal and body ground.
ls there approx. 5 V?
YES Replace the VSS. !
NO -- Replace the short to ground or open in the
BLU,^/vHT wire. t
7 .
8 .
9 .
1 0 .
1 1 .
1 2 .
W i r e s i d e o f f e m a l e t e r m i n a l s
22-54
Maintenance Required Indicator
Reset Procedure
How to Reset:
Push and hold the trip button. turn the ignition switch
O N ( l l ) , a n d c o n t i n u e h o l d i n g t h e t r i p b u t t o n I o r m o r e
than 10 seconds.
At 5,900 (9,440)
to 6.100 (9.760
B l i n k s f o r 1 0 s e c o n d s w h e n t h e
Comes on and stays on while
A t 7 , 4 0 0 ( 1 1 , 8 4 0 )
1 . 6 0 0 t 1 2 . 1