Door Weatherstrip Replacement
NOTE:
. Take care not to scratch the door.
. Use a clip remover, to remove the clips.
1 . R e m o v e t h e d o o r p a n e l { s e e p a g e 2 0 - 4 ) .
2. Remove the door weatherstrip as shown.
3. Installthe weatherstrip in the reverse order of
removal, and note these items:
. Replace any damaged clips.
. lf the old weatherstrip is to be reinstalled, scrape
off all traces of old EPT sealer and butyl tape,
then clean the weatherstrip surface with alcohol.
. Glue the new weatherstrip into place using EPT
sealer and butyl tape.
Fastener Locations
A ) : S c r e w , 2 B
EPT SEALER
Thickness:5 mm (0.2 in.)
Width:5 mm {0.2 in.l
BUTYL TAPE
Thickness: 1 mml0.04 in.l
Wideth: 5 mm {0.2 in.l
WEATHERSTRIP
Door Wedge and Door Wedge
Holder Replacement
NOTE: Take care not to scratch the door and body.
1. Remove lhe door wedge and the door wedge
h o l d e r a s s h o w n .
2. Install the wedge and wedge holder in the reverse
order of removal, and when installing the door
wedge holder, adjust it up or down untilthe door
wedge is centered in the holder.
Fastens. Locations
2
B
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m,
7.2 tbl.ttl
DOOR WEDGE
) : Screw,
rN,",,,,-
\).*
) : Screw
@
, 2
6 x 1 . 0 m m
9.8 N.m
(1.0 kgf.m,
7 .2 tbf.ftl
DOOR WEDGE
HOLOER
\
^ .
20-17