Wring Precautions
Some of the SRS wiring can be identified by a special
yellow outer covering, and the SRS connectors can be
identified bv their vellow color.
Observe the instructions described in this section.
. Never attemptto modify. splice, or repair SRS wiring.
l f t h e r e i s a n o p e n o r d a m a g e i n S R S w i r i n g , r e p l a c e
the harness.
Be sure to install the harness wires so they do not get
pinched, or interfere with other pans.
. Make sure all SRS ground locations are clean, and
grounds are securely fastened for optimum metal-to-
metal contact. Poor grounding can cause intermittent
problems that are difficult to diagnose.
Precautions for Electrical Inspections
. When using electrical test equipment, insertthe
Drobe of the tester into the wire side of the connector.
Do not insert the Drobe of the tester into the terminal
side of the connector, and do not tamper wlth the
connecror.
Use a U-shaped probe. Do not insert the probe
fo rcibly.
Use specified service connectors in troubleshooting,
Using improper tools could cause an error in
inspection due to poor metal-to-metal contact.