Honda S2000 Service Manual page 707

Glass
Glass Replacement Process (cont'd)
9. Carefully remove the glass.
'10. With
a knife, scrape the old adhesive smooth to a
thickness of about 2 mm {0.08 in.) on the bonding
surface around the entire glass opening flange:
. Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper
b o n d i n g .
. Remove any remaining parts from the body.
1
't.
Clean the body bonding surface with a sponge
dampened in alcohol. After cleaning, keep oil,
grease and water from getting on the clean surface.
12. lf the old glass is to be reinstalled, use a putty knife
to scrape off all of the old adhesive and any
remaining parts from the glass. Clean the inside
face of the glass with alcohol where new adhesive
is to be applied. Make sure the bonding surface is
kept free of water, oil and grease.
13, Glue the rubber dam (A), fastener (B), and other
parts to the inside Jace of the glass (C). windshield
(see page 20-29), rear window (see page 20-32). Be
careful not to touch the glass where adhesive will
b e a p p l i e d .
-
Inside N
^
*
-A..-"
-N
-u-
20-26
14. Glue the molding (A) with adhesive tape (B) to the
edge ofthe glass (C), windshield (see p age 20-291,
rear window (see page 20-32). Be careful not to
touch the glass where adhesive will be applied.
Install the fastener (A) to the body, windshield (see
page 20-29), rear window (see page 20-321.
t 5 .