sRs
1 5 .
1 3 .
1 4 .
DTC Troubleshooting (cont'd)
' 1 1 . D i s c o n n e c t t h e S R S u n i t l 8 P c o n n e c t o r ( A ) f r o m t h e
SRS unit.
Disconnect the special tool from the SRS main
haress.
Reconnect the battery negative cable.
T u r n t h e i g n i t i o n s w i t c h O N ( l l ) .
Check for voltage between the No. 10 terminal of
the SRS unit 18P connector and body ground, and
between the No. 14 terminal and body ground.
T h e r e s h o u l d b e 0 . 5 V o r l e s s .
SRS UNIT 18P CONNECTOB
Wire side of female terminals
ls the voltage as specified?
YES Faulty SRS unit; replace the SRS unit (see
page 23-15).a
NO Shortto power in the SRS main harness;
r e p l a c e t h e S R S m a i n h a r n e s s . I
23-36
DTC 2-5: Short to Ground in Passenger's
Airbag Inflato r
SpecialTools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead C 07TAZ-S25011A
1. Erase the DTC memory (see page 23-19).
2. Turn the lgnition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator staY on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnectthe
battery negative cable, and wait for 3 minutes.
4, Disconnect the passenger's airbag 2P connector
f r o m t h e S R S m a i n h a r n e s s ( A ) .
Connect the SBS inflator simulator (2 0 connector)
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n h a r n e s s .
5 .