Honda S2000 Service Manual page 634

9. Apply Molykote M77 grease or Daikalub 528D
grease to the pad side of the shims (A) and back of
the pads (B). Wipe excess grease offthe shim.
Contaminated brake discs or pads reduce stopping
ability. Keep grease off of the discs and pads.
A
Install the brake pads and pad shims correctly.
Install the pad with the wear indicator (C) on the
inside.
lf you are reusing the pads. always reinstall the
brake pads in their original positions to prevent a
momentary loss of braking efficiency.
' 1 0 .
1 1 .Push in the piston (A) so that the caliper will fit over
the pads. N4ake sure the piston boot is in position to
prevent damaging it when pivoting the caliper
down.
D
32 N.m (3.3 ksf.m,24lbf.ftl
12. Pivotthe caliper (B) down into position, being
careful not to damage the pin boot. Hold the caliper
pin (C) with a wrench, being careful not to damage
the pin boot. Installthe caliper bolt (D), with
another wrench, and torque it to proper
soecification,
13. Press the brake pedal severaltimes to make sure
the brakes work, then road-test
NOTE: Engagement of the brake may require a
greater pedal stroke immediately after the brake
pads have been replaced as a set. Several
applications of the brake pedal will restore the
normal pedal stroke.
14. After installation. check for Ieaks at hose and line
jo:nts or connections, and retighten if necessary.
1 9 - 1 3