J
Check for loose retainer (A) and rubber seals (B).
The backs of some connectors are packed wilh
dielectric grease. Add grease if necessary. lf the
grease is contaminated, replace it.
(P/N 08798-90011
Insert the connector all the way and make sure it is
securely locked.
Position wires so thal the open end of the cover faces
down.
Handling Wires and Harnesses
. Secure wires and wire harnesses to the frame with
their respective wire ties at the designated locations.
. Remove clips carefully; don't damage their locks (A).
S l i p p l i e r s ( A ) u n d e r t h e c l i p b a s e a n d t h r o u g h t h e
hole at an angle, then squeeze the expansion tabs to
release the clio.
After installing harness clips, make sure the harness
doesn't interfere with any moving parts,
Keep wire harnesses away from exhaust pipes and
other hot parts. from sharp edges of brackets and
holes, and from exposed screws and bolts.
Seat grommets in their grooves properly (A). Do not
leave grommets distorted (B).
-W
R
It
(cont'd)
l
/
o
) t /
r1J \ t/
5E;j=-
't
t,
I
22-3