Honda S2000 Service Manual page 590

Front Suspension
Knuckle/Hub Replacement (cont'd)
SpecialTools Required
. Ball joint remover, 28 mm 07MAC-S100200
. Bearing driver attachment, T2 x 75 mm 07746-0010600
. Driver, 07749-0010000
. Support base, 72 x 78/82.6 mm 07965-SD90100
. Hub dis/assembly tool, 07GAF-SD40200
'1.
Raise the front ofthe vehicle, and suppon itwith
safety stands in the proper locations
( s e e p a g e 1 - 1 3 ) .
2. Remove the wheel nuts (A) and the front wheel.
3. Remove the brake hose bracket mounting bolt (A).
9 . 8 N m
(r.0 kgt.m,
7 .2 tbt.ttl
',
108 N m
'
111.0 ksf.m,
79.6 tbf.ft)
Remove the caliper bracket mounting bolts (B), and
r e m o v e t h e c a l i p e r a s s e m b l v ( C ) f r o m t h e k n u c k l e .
To prevent damage to the caliper assembly or
brake hose, use a shon piece of wire to hang the
caliper assembly from the undercarriage. Do not
twist the brake hose with force.
18-12
5. Remove the flange bolts (A) and wheel sensor (B)
from the knuckle (C). Do not disconnect the wheel
sensor connector.
A
9 . 8 N m
(1.0 kgf.m,
7.2 tbl.ttl
l r
6. Remove the 6 mm brake disc retaining screws (A).
A
9.8 N.m
{1.0 kgf.m,
7.2lbt.ttl
1 . Screw two 8 x 1.25 mm bolts (B) into the disc to
push it away from the hub. Turn each bolt two turns
at a time to prevent cocking the disc excessively,
Remove the brake disc from the knuckle.
Check the hub for damage and cracks. 9 .
i i /
r t l