Fuel Pump/Fuel Gauge Sending Unit Replacement - Honda S2000 Service Manual

Fuel Supply System
Fuel Pump/Fuel Gauge Sending Unit Replacement
1. Remove the reartray (see page 20-71).
2. Remove the access panel fromthefloor.
3. Turn the ignition switch OFF.
4. Disconnect the fuel pump 5P connector.
5. Remove the fuel fill cap.
6 . R e l i e v e t h e f u e l p r e s s u r e ( s e e s t e p T o n p a g e 1 1 -
1 0 3 ) .
7. Disconnect the quick-connect fittings from the fuel
p u m p .
8 . R e m o v e t h e b o l t s ( A ) a n d t h e f u e l t a n k u n i t { B ) .
9 ^ -
e E
11-114
9. Remove the bracket (A), the fuelfilter (B), the fuel
g a u g e s e n d i n g u n i t ( C ) , t h e h o s e ( D ) , a n d t h e w i r e
h a r n e s s ( E ) .
tl
When connecting the fuel pump, make sure the
connections are secure and the suction filter (H) is
firmly connected the fuel pump (l).
lnstallthe unit in the reverse order of removal with
a new base gasket, then check these items:
. When connecting the wire harness, make sure
the connection is secure and the terminal (F) is
firmly locked into the place.
. C h e c k t h a t t h e t a b o f t h e c l a m p ( G ) d o e s n o t
interfere with the wire harness.
. Do not push the lower part of the suction filter.
. W h e n i n s t a l l i n g t h e f u e l g a u g e s e n d i n g u n i t ,
make sure the connection is secure and the
connector is firmly locked into place. Be careful
not to bend or twist it excessively.
. Check for fuel leaks.
1 0 .
1 1 .