ABS Components
Wheel Sensor Inspection
Inspect the front and rear pulsers for chipped or
damaged teeth.
Measure the air gap between the wheel sensor and
pulser all the way around while rotating the pulser.
Remove the rear brake disc to measure the gap on
the rear wheel sensor. lf the gap exceeds 1.0 mm
( 0 , 0 4 i n ) , c h e c k f o r a b e n t s u s p e n s i o n a r m .
Standard:
Front/Rear: 0.4 1.0 mm (0.02 0.04in.)
Front/Bear
0 , 4 - 1 . 0 m m
10.02-0.0it in.l
1 .
19-60
Wheel Sensor Replacement
NOTE; Install the sensors carefully to avoid twisting the
wires.
Front:
6 mm BOLT
9,8 N.m (1.0 kgf.m, 7.2lbf.ft)
Rear:
\
mm BOLT
WHEEL SENSOR
9.8 N.m (1.0 kgI.m,
1.2 tbt.ftl
6 mm BOLT
9.8 N.m (1.0 kgf m,
7.2lbf.ftl
9.8 N m {1.0 kgl.m, 7.2 lbf ft)