Table of Contents
Advertisement
Rear Suspension
Stabilizer Bar Replacement
' 1 . Raise the rear of the vehicle, and suppon it with
safety stands in the proper locations
{ s e e p a g e 1 - 1 3 } . R e m o v e t h e r e a r w h e e l
Remove the self-locking nuts (A) while holding the
joint pins (B) with a hex wrench (C). and disconnect
the stabilizer links (D) from the stabilizer bar {E) on
the right and left.
A
10 x 1 ,25 mm
43 N.m (i1.4 kgf.m, 32 lbf.ftl
Remove the bolts (A) and bushing holders (B), then
remove the bushings (C) and the stabilizer bar (D)
lnstall the stabilizer bar in the reverse order of
removal.
NOTE: Refer to Stabilizer Link Replacement to
connect the stabilizer bar to the links.
18-34
Stabilizer Link Removal/lnstallation
1 . Raise the rear of the vehicle, and support it with
safety stands in the proper locations
( s e e p a g e 1 - 1 3 ) . R e m o v e t h e r e a r w h e e l .
Remove the self-locking nut (A) and flange nut (B)
while holding the respective joint pins (C) with a
hex wrench (D), and disconnect the stabilizer link
(E) from the stabilizer bar (F) and the lower arm (G).
lnstall the stabilizer link to the stabilizer bar and
Iower arm with the joint pins set at the center of
t n e r r r a n g e .
Advertisement
Table of Contents
Troubleshooting
