sRs
DTC Troubleshooting (cont'd)
DTC 1-5: Short to Ground in Driver's Airbag
lnflator
Special Tools Required
. SRS inflator simuiator 07SAZ-T8401'lA
. SRS simulator lead C 07TAZ-S25011A
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition swltch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO lntermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's airbag 2P connector lrom
the cable reel (A).
07TAZ-SZ501rA
Connectthe SRS inflator simulator (2 Q connector)
and the simulator lead to the cable reel.
Reconnect the battery negative cable.
Erase the DTC memory,
6.
7 .
23-30
9 .
1 0 .
Read the DTc.
ls DTC 1-5 indicated?
YES - Go to step 9.
NO Shortto ground in the driver's airbag; replace
the driver's airbag (see page 23'65).1
Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the cable reel 2P connector from the
S R S m a i n h a r n e s s ( A ) .
07TAZ-S25011A
----R(N
\p
_---_--n.#
07sAz-T84011A '-'
t
1 1 .Connectthe SRS inflator simulator (2 Q
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n
Reconnect the battery negative cable.
Erase the DTC memory.
connector)
h a r n e s s .
1 3 .