Honda S2000 Service Manual page 467

7 . I n s t a l l t h e w i r e h a r n e s s ( A ) t o t h e t r a n s m i s s i o n ,
then connect the Dick-uo sensor connector (B).
-
r ar'-] I
8 . Raise the transmission, then install the three
transmission rear mount bolts.
10 x 1.25 mm
38 N.m (3.9 kgf.m,28 lbf.ft)
9. Place a floor jack under the front subframe and the
engine mounting stiffener, and raise it to the frame.
SPECIAL BOLTS
Replace.
1 4 x 1 . 5 m m
1't6 N.m (11.8 ksf.m,85.3 lbf.ft)
. ' . . . / . j
SPECIAL BOLTS
Replace.
1 2 x 1 . 2 5 m m
59 N.m 16.0 kgf.m, 43 lbf.ft)
10. Tighten thefourmounting bolts, and install the two
center mounting bolts.
11. Install the five lower transmission mounting bolts.
10 x 1.25 mm
12x 1.25 mtn
64 N.m {6.5 kgf m.47 lbt ft)
(cont'd)
13-67