Hardtop Lower Weatherstrip Replacement - Honda S2000 Service Manual

Removable Hardtop
Hardtop Lower Weatherstrip Replacement
NOTE:
. To remove and install the hardtop lower weatherstrip, remove the roof from the body
. Take care not to scratch the roof,
. Use a clip remover to remove the cllps.
1. Remove the rear window lower trim (see page 20-55).
2, Remove the hardtop lower weatherstrip as shown.
3. Install the weatherstrip in the reverse order of removal, and note these items:
. Before installing the weatherstrip, clean the roof bonding surface with alcohol.
. l f t h e o l d w e a t h e r s t r i p i s t o b e i n s t a l l e d , s c r a p e o f f t h e d o u b l e - f a c e d a d h e s i v e t a p e , t h e n c l e a n t h e w e a t h e r s t r i p
surface with alcohol. Glue the new double-faced adhesive tape (3M 5304, or equivalent) to the weatherstrip.
. Replace any damaged clips.
. Before installing the weatherstrip, fold the edge of the adhesive backlng from the double-faced adhesive tape.
After installing the weatherstrip, carefully pull the adhesive backing away.
. Press the double-faced adhesive tape portion to make the adhesive stick.
Fastener Locations
A ) : S c r e w , 2 B > : c l i p , 2 C
p : Clip, 19
ff
. : l t I -
\e:>
DOUBLE. FACED
ADHESIVE TAPE
Thickness:0.8
mm (0.03 in.)
Width: 6 mm (0.24 in.)
EPT SEALER
Thickness: 3 mm (0.1 in.)
W i d t h : 5 m m ( 0 . 2 i n . )
UPPER DOOR GLASS
WEATHERSTRIP
\
lAl portions:
HARDTOP LOWER
WEATHERSTRIP
A
A
Adhesive tape area.
A
20-60