Honda S2000 Service Manual page 630

2. Have someone slowly pump the brake pedal
severaltimes, then apply steady pressure.
Starting at the left-front, loosen the brake bleed
screw to allow air to escape from the system. Then
tighten the bleed screw securely.
Repeat the procedure for each wheel in the
sequence shown below until air bubbles no longer
appear in the fluid.
5. Refillthe master cylinder reservoir to the MAX
( u p p e r ) l e v e l l i n e .
BLEEDING SEOUENCE:
, Front Right 0 Rear Right
O Front Left O Rear Lelt
Pressure Bleeding
Installthe appropriate power probe pressure bleeder
adapter onto the master cylinder.
Use the bleeding sequence above, and follow the
bleeding instructions that come with your pressure
b l e e d e r .
Bleed Screw Locations
FRONT:
REAR:
19-9