6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 2-5 indicated?
YES Go to step 9.
NO - Short to ground in the passenger's airbag;
replace the passenger's airbag (see page 23-67).1
Turn the ignition switch OFF. then disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag 2P connector (A) and
both seat belt tensioner 2P connectors (B).
1 0 .
11. Disconnect the SRS unit 18P connector (A) from the
SRS unit.
Disconnect the special tool from the SRS main
harness.
Check resistance between the No, 10 terminal of
the SRS unit 18P connector and body ground, and
the No. 14 terminal and body ground. The.e should
be an open circuit, or at least 1 M Q .
SRS UNIT 18P CONNECTOR
' t 2 .
1 3 .
Wire side of female terminals
ls the resistance as specified?
YES - Faulty SRS unit; replace the SRS unit (see
page 23-75).1
N O - S h o n t o g r o u n d i n t h e S R S m a i n h a r n e s s ;
replace the SRS main harness.l
,l
3
4
5
6
1
I
I
10
l 1
12
t o
1 4
t 5
1 6 1 7 1 8
GRN
GRN
23-37