Dtc 3-1: Open In Driver's Seat Belt Tensioner; Dtc 3-2: Increased Resistance In Driver's Seat Belt Tensioner - Honda S2000 Service Manual

sRs
DTC Troubleshooting (cont'd)
DTC 3-1: Ooen in Driver's Seat Belt Tensioner
DTC 3-2: Increased Resistance in Driver's
Seat Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SM-TB4011A
. SRS simulator lead C 07TAZ-S25011A
1. Erase the DTC memory (see page 23- 19).
2. Turn the ignition switch ON (ll). and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator staY on?
YES Go to steD 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver's seat belt tensioner 2P
connector from the SRS main harness {A).
Connect the SRS inflator simulator (2 Q connector)
and the simulator lead to the SRS main harness.
07TAZ-S25011A
23-38
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-1 or DTC 3-2 indicated?
YES-Go to step 9.
NO-Open or increased resistance in the driver's
seat belt tensioner; replace the driver's seat belt
(see Page 23-4).1
9. Turn the ignition switch OFF, then disconnecl the
battery negative cable, and wait for 3 minutes.