Clutch Pedal And Clutch Interlock Switch Adjustment - Honda S2000 Service Manual

Glutch
Clutch Pedal, Clutch Pedal Position Switch, and Clutch Interlock Switch
Adjustment
NOTE:
. To checkthe clutch pedal position switch (see page 4-
4 7 ) .
. To check the clutch interlock switch (see page 4-6).
. The clutch is self-adjusting to compensate for wear.
. lf there is no clearance between the mastercylinder
piston and push rod, the release bearing is held
against the diaphragm spring, which can result in
clutch slippage or other clutch problems.
1. Loosen locknut (A), and back offthe clutch switch
(B) until it no longer touches the clutch pedal (C).
H
9.8 N.m (1.0 kgt.m, 7.2 lbt.ftl
2. Loosen locknut (D), and turn the push rod (E) in or
out to get the specified height (F) and stroke (G) at
the clutch oedal.
Clutch Pedal Stroke: 115 125 mm {4.53 4.92 in.)
Clutch Pedal Height: 189 mm (7.44 in.)
3. Tighten locknut (D).
4. With the clutch pedal released, turn the clutch
Dedal Dosition switch {B) in until it contacts the
clutch pedal (C).
{1.0 kgf m,
7.2 tbf.ft)
12-4
5. Turn the clutch pedal position switch {B) in an
additional 3/4 to 1 turn.
6. Tighlen locknut (A).
7. Loosen locknut (H) andthe clutch interlock switch
( t ) .
8. Press the clutch pedal to the floor.
9 . R e l e a s e t h e c l u t c h p e d a l
' 1 5 - 2 0 m m ( 0 . 5 9 - 0 . 7 9 i n . )
from the fully depressed position, and hold lt there.
Adjust the position of the clutch interlock switch (l)
so that the engine will start with the clutch pedal in
this position.
1 0 . T i g h t e n l o c k n u t ( H ) .