Honda S2000 Service Manual page 1076

41. Connect a Honda PGM Tester (A) to the data link
connector (B) and follow the Tester's prompts in
the
"SCS" menu (see the Tester's operating
m a n u a r r .
-e
42. Check resistance between the No.9 terminal ofthe
SRS unit 18P connector and body ground. There
s h o u l d b e 0 - 1 . 0 Q .
ls the rcsistance as specitied?
YES - Faulty SRS unit or poor contact at the SRS
unit 18P connector; check the connection; if the
connection is OK, replace the SRS unit (see page
23-751..
NO Open in the SCS line between the No. 9
terminal of the SRS unit 18P connector and the
No.9 terminal (BRN wire) ofthe data link connector
(DLC) or open between the No. 4 terminal of the
DLC and body ground. Repair the open wire (s).
SRS UNIT 18P CONNECTOR
Wire side of female terminals
23-63