Rear Differential
1 4 .
Differential Reassembly (cont'dl
Install the Torsen LSD assembly (A), bearing outer
races (B), adjustment screws (C) onto the
differential carrier housing.
NOTE:
. Reinstallthe adjustment screws in their original
position on the differential carrier housing.
. Align the threads of the adjustment screws and
differential carrier housing.
I n s t a l l t h e b e a r i n g c a p s { A ) w h i l e a l i g n i n g b o t h t h e
ma rks (B) on the threads of the adjustment screws
a n d b e a r i n g c a p s , t h e n i n s t a l l t h e m o u n t i n g b o l t s
fingertight.
t 5 .
15-22
16. Measure the backlash of the ring gear.
Set the dial gauge tip at a right angle to the ring
gear teeth.
Measure four points on the ring gear 90" apan.
Backlash will be within the standard if at one
point the ring gear backlash is within the
standard, minimum measurement of 0.05 mm or
above and the difference between the maximum
and minimum measurements do not exceed 0.07
m m .
Both adjustment screws must be adjusted.
Backlash:
Standerd: 0.09 '- 0.11 mm 10.0035 0.0043 in.)
Minimum: 0.05 mm (0.0020 in.)
Difference range: 0.07 mm (0.0028 in.)