Honda S2000 Service Manual page 141

13. Remove two bolts (A) securing the intake manifold
bracket, and remove the water bypass hose (B).
Remove the engine wire harness connectors and
wire harness clamps from the cylinder head and
intake manifold.
1 4 .
Four fuel injector connectors
lntake air temperature (lAT) sensor connector
ldle air control (lAC) valve connector
Throttle position (TP) sensor connector
Manifold absolute pressure (MAP) sensor
connecror
Engine coolant temperature {ECT) sensor
conneclor
Primary heated oxygen sensor (primary HO2S)
connecror
VTEC solenoid valve connector
VTEC oressure switch connector
Crankshaft Dosition (CKPI sensor connector
1 5 . Remove the four bolts securing the exhaust
manifold cover.
" \ ,
, ) ,
l - i
16. Remove the three bolts (A). and loosen the bolt {B),
t h e n r e m o v e t h e h e a t s h i e l d ( C : .
(cont'd)
1rfu
6-27