Exterior Lights
Side Turn Signal Light Replacement
1 . P u s h t h e s i d e t u r n s i g n a l l i g h t ( A ) f o r w a r d , t h e n
remove it from the fender.
Side Turn Signal Light Bulb: 5 W
2. Disconnect the 2P connector (B)from the light.
22-7 4
Taillight Replacement
NOTE; For bulb replacement, see the owner's manual.
1 . O p e n t h e t r u n k l i d a n d p u l l b a c k t h e t r u n k t r i m
panel (see page 20-73).
2. Disconnect the connectors (A)from the taillight.
Brake/Taillight:
2115W
Back-up Light:
21W
Turn Signal Light:
21W
Side Marker Light:
5 W
Remove the four mounting nuts (B), then pull out
t h e t a i l l i g h t .
Before installing the taillight, check the gasket. lf it
is distorted or stays compressed, replace it.
Install the taillight in the reverse order of removal.
After installing the taillight. run water over it to
make sure it does not leak,
]t
5 .
6 .