Honda S2000 Service Manual page 160

Cylinder Head
Gylinder Head Installation (cont'd)
Installthe dowel pins (A) and the new cylinder head
gasket (B).
B
Apply liquid gasket, part No. 08718-0009, to the
cylinder head mating surface of the block and chain
c a s e w i t h i n 5 m m o f t h e e d g e o f t h e c y l i n d e r h e a d
gasket.
6-46
6 .
7 .
Install the cylinder head on the block.
A p p l y e n g i n e o i l t o t h e t h r e a d s a n d u n d e r t h e h e a d s
o f a l l t h e c y l i n d e r h e a d b o l t s .
8. Tighten the cylinder head bolts in sequence to
29 N m (3.0 kgf.m, 22 lbf ft). Use a beam-type
torque wrench. When using a preset-type torque
wrench, be sure to tighten slowly and do not
overtighten. lf a bolt makes any noise while you are
torquing it, Ioosen the bolt and retighten it.
Tighten all cylinder head bolts in two steps {90' per
step). lf you are using a new cylinder head bolt,
tighten the bolt an extra 90".
SECOND STEP
Tighten the 8 mm bolts (A)ro 22 N.m (2.2 kgf.m,
1 6 l b f . f t ) .
9 .
1 0 .