Fwd/Trans To Outside Line - AT&T SB67030 Administrator's Manual

Fwd/Trans to Outside Line

The SA may enable or disable the ability of each Deskset to forward or transfer a call to an outside line because these features
use two of your telephone lines. This function is enabled by default. Disabling this function prohibits the user from sending a call
to an outside line via the Gateway.
To toggle the Forward/Transfer to an outside line:
Figure 37. Fwd/Trans to Line
Figure 38. Toggle Fwd/Trans
Getting Started
Synapse Administrator's Guide
1. Access the Admin Settings menu: Press MENU, then press 3 on the dial pad,
then enter the Admin password, and press SELECT.
2. Press 2 on the dial pad to display the Fwd/Trans to line screen shown in
Figure 37, with the current setting displayed.
Navigation key to toggle the setting between Enabled and
3. Press the or
Disabled, as shown in Figure 37 and Figure 38.
to accept the changes and return to the Admin Settings menu.
4. Press
If Call Fwd–NA is set to
pressing after changing the
Fwd/Trans to line from Enabled to
Disabled causes the screen shown in
Figure 39 to appear.
51
Fwd/Trans to line
,
Call Fwd-NA Target
to Ext:
Call Fwd-NA is now set to
OFF. The forwarding
to Line:
target has been disabled.
Call Fwd-NA Delay
Use or to mov e highlight.
Use or to cy cle through options.
Save
Figure 39. Fwd/Trans to Line
Disabled
VM
30
Quick
Dial