Recovery After Power Failure - AT&T SB67030 Administrator's Manual

Recovery After Power Failure

The Synapse system automatically recovers after a power failure. The following describes the recovery process.
Allow about a minute for the Gateway to boot up when power returns after a power failure.
The Gateway power-up sequence follows:
1. About 20 seconds after turning on power to the Gateway, the POWER LED turns on.
2. When the Gateway finds the network, Synchronizing... momentarily displays to
indicate that the Gateway is in the process of detecting and synchronizing with other
system devices, as shown in Figure 17.
3. Once the Gateway has successfully finished synchronizing with the rest of the system,
Synchronized displays, as shown in Figure 18.
This is the Idle screen that shows the time, date, system status, and IP address.
The time and date may not be correct. The time and date are set using the WebUI
"System Basic Settings" on page
[ATA] The optional ATA also automatically restarts and synchronizes after an AC
power failure.
The system assigns a link-local address, which starts with 169.254.
System Description
Synapse Administrator's Guide
76.
35
Figure 17. Synchronizing
Figure 18. Synchronized