[T1] T1 Diagnostics - AT&T SB67030 Administrator's Manual

[T1] T1 Diagnostics

You can check the status of the T1 Gateway and select a loopback mode. Setting the loopback mode terminates any phone calls
that are using the T1 Gateway.
To view the T1 Status:
Figure 158. T1 Diagnostics, Part 1
System Configuration
Synapse Administrator's Guide
1. Log in as administrator. See
page 68.
2. Click System Settings, then T1 Diagnostics in the Navigation
Menu at left. The screen shown in Figure 158 appears.
The current T1 configuration is shown.
3. Optional: Put the T1 in loopback test mode by selecting from the
Set Loopback Mode drop-down list, then clicking
that the Alarm State color changes accordingly.
Selecting Network loopback allows the service provider to test
the T1 circuit.
Selecting Payload loopback allows the service provider to test
both the circuit and the T1 Gateway's ability to encode and
decode the T1 data.
Once loopback testing is completed, select none, then click
to cancel any loopback test mode.
Be sure to cancel loopback testing so that telephone calls
can again occur.
166
"Log in as Administrator" on
. Note