[T1] Did Assignments - AT&T SB67030 Administrator's Manual

[T1] DID Assignments

If you did not enable automatic assignment (see
In addition to the manual assignment process described in this section, you can also manually assign DID numbers on the
Extension Basic Settings screen (see
Settings screen (see
"[ATA] ATA Settings" on page
If you are reconfiguring an existing system, see
The Direct Inward Dial Assignments screen, shown in
To manually assign Direct Inward Dial numbers:
Figure 102. DID Assignments, Part 1
System Configuration
Synapse Administrator's Guide
"[T1] DID Configuration" on page
"Extension Basic Settings" on page
158).
"Reconfiguration of an Existing System" on page
Figure 100 on page
105
101), you must manually assign DID numbers.
146), and if an optional ATA is present, on the ATA
143.
103, displays all DID numbers and their assignments.
1. Log in as administrator. See
Administrator" on page
2. Click System Settings, Direct Inward Dial,
and then DID Assignments in the Navigation
Menu at left. The screen shown in Figure 102
appears.
3. Sort the fields in the Direct Inward Dial
Assignments table as desired. Clicking the
buttons above each column changes which
column the information is sorted by. Press the
button again to change between ascending and
descending order.
button to display the Extension
4. Click the
Basic Settings screen for that extension, as
shown in Figure 103 on page
"Log in as
68.
106.