[Handset] Sb67040 Cordless Handset - AT&T SB67030 Administrator's Manual

[Handset] SB67040 Cordless Handset

For more information about the corrective actions recommended in this troubleshooting section, see the Synapse User's
www.telephones.att.com/synapseguides
Guide at
Symptom
Handset does not work at all
(LCD is black).
Extension number does not
match the Deskset.
Troubleshooting
Synapse Administrator's Guide
Probable Cause
There is no power to the
device.
The Handset has been
registered to another
Deskset.
.
Corrective Action
Confirm the battery is installed and charged correctly.
Place the Handset into the accessory charger. Ensure the
charger is securely plugged into an outlet not controlled
by a wall switch. The Charge LED on the accessory
charger should light and the Handset display should
indicate that the Handset is charging.
Verify that the charger's AC power outlet has power, such
as plugging in some other AC device. If nothing works,
contact an electrician or use another power outlet.
If the battery is completely depleted, it can take up to 10
minutes to charge the battery before the low battery icon
displays on screen.
1. Check the Deskset to see if a Handset has been
registered. If so, deregister it. On the Deskset, press
MENU –> User Settings –> Cordless Settings –>
Handset –> DeReg.
2. Deregister your Handset. On the Handset, press
OPTIONS –> Settings –> Deregister.
3. Start the registration process again. Register the Handset
at the Deskset. Press MENU –> User Settings –>
Cordless Settings –> Handset –> Register.
233
Cordless Handset