To configure the T1 settings: (Continued)
Figure 157. T1 Settings, Part 3
System Configuration
Synapse Administrator's Guide
165
6. Select the Number of Channels. The SA can set
the number of voice channels available on the T1
trunk according to the current service
subscription. Channel 24 is reserved for PRI
signaling.
7. Select the Lowest Voice Channel in cases
where some channels are reserved for data
transfer or if there are limited slots available.
8. Select the Outbound Channel Selection Order,
either Ascending or Descending.
9. Click
to save any changes or click
to return to the previous screen without saving
the changes.
10. Restart the T1 Gateway. Restarting the T1
Gateway hangs up any active calls that are using
the T1 Gateway.
Press RESET on the T1 Gateway front panel
for less than 5 seconds.
OR
Disconnect and reconnect T1 Gateway AC
power.