Fwd/Trans To Outside Line; Ip Settings - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide

Fwd/Trans to Outside Line

You can enable or disable the ability of each Deskset to forward or transfer a call to an
outside line. These features use two of your telephone lines. This function is enabled by
default. Disabling this function prohibits the user from sending a call to an outside line
via the Gateway.
To enable or disable Forward/Transfer to an outside line:
1. On the Admin Settings menu, press 2 to display the Forward/Transfer to line
screen.
Forw ard / Transfer
Fw d/Trans to Outside Line:
Save
2. Press
3. Press

IP Settings

On the IP Settings menu, you can manually configure the Deskset IP address. See
"Appendix B: IP Addresses and Connectivity" on page 104
network configuration and IP settings.
To display the IP Settings screen:
1. On the Admin Settings menu, press 3 to display the IP Settings screen.
IP Settings
1. IP Configuration
2. Set/Edit Static IP
3. IP Status
2. Perform one of the following:
Press 1 to select IP Configuration. See
a.
page
b. Press 2 to select Set/Edit Static IP. See
page
Press 3 to select IP Status. See
c.
Device Configuration
Enabled
 
to select Enabled or Disabled.
or
to accept the changes and return to the Admin Settings menu.
Save
If Intercom Call Forward–No Answer is set to Phone#, disabling
Fwd/Transfer to Outside Line causes a warning message to appear,
warning you that Call Forward–No Answer is set to OFF. You may want to
select a new target for the Intercom Call Forward–No Answer setting.
81.
81.
80
for a discussion of the Syn248
"To set the IP Configuration:" on
"To set and edit static IP Address:" on
"To view the IP status:" on page
Back to Contents
81.