[Ata] Overhead Paging (Ohp) - AT&T SB67030 Administrator's Manual

[ATA] Overhead Paging (OHP)

Symptom
Overhead paging (OHP) is
not working.
Troubleshooting
Synapse Administrator's Guide
Probable Cause
You don't know whether your
OHP is single- or multi-zone
and whether it needs an FXS
or an Audio-Out connection.
Corrective Action
There are three possible configurations for OHP:
Single-zone paging connected to the AUX OUT jack.
Single-zone paging connected to one of the two FXS
ports.
Multi-zone paging connected to one of the two FXS
ports.
Select the appropriate configuration for your specific
paging equipment. For more information about the
different configurations, see
Overview" on page 122.
Refer to your OHP product documentation and the
respective troubleshooting section below. The paging
equipment, the jack it is plugged into, and the WebUI must
all match.
250
ATA OHP
"[ATA] Overhead Paging