AT&T SB67030 Administrator's Manual page 147

To set the Extension Basic Settings for the administrator: (Continued)
Figure 140. Basic Extension Settings, Part 2
Desksets do not lose their assigned extensions even if a
Deskset is disconnected and unplugged for a substantial
length of time. If you want to remove a Deskset from the
network, the extension must be deleted. (See
an extension, Gateway, or ATA:" on page
ensures that the Deskset does not tie up an extension.
System Configuration
Synapse Administrator's Guide
5. [T1] You can assign or change a Direct Inward Dialing
6. [T1] If you selected a DID number for the extension,
7. You can enter a new extension number in the range
"To delete
170.) This
8. You can select Call Forward/Transfer to Outside
147
number for this extension using the Select DID drop-
down list, as shown in Figure 140. Select Unassigned
to release a previously assigned DID number.
the Outgoing Caller ID option appears. Select
whether the Outgoing Caller ID is the DID number or
the System Pilot Number.
100-999 or 1000-9999 into the Change Extension
Number to box. The first digit of the extension
number need not match the default extension number
first digit.
Ensure that the extension is not in use and do
not assign an extension number with the first
digit of any extension that is the same as an
Auto Attendant menu digit key value, as callers
will be unable to dial that extension. Instead,
they will be connected to that Auto Attendant
menu action. See"Auto Attendant" on page
Telephone Number to enable or disable forwarding
or transferring of calls to an outside telephone via the
outside phone lines plugged into the Gateway. This
function is enabled by default and uses two phone
lines when calls are forwarded. Disabling this function
prohibits the user from forwarding or transferring a
call to an outside phone number.
81.