Removing the MX240 Craft Interface
To remove the craft interface (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Detach any external devices connected to the craft interface.
3. Loosen the captive screws at the left and right corners of the craft interface faceplate.
4. Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
5. Disconnect the ribbon cable from the back of the faceplate by gently pressing on both sides of the
latch with your thumb and forefinger. Remove the craft interface from the chassis.
Figure 101: Removing the Craft Interface
SEE ALSO
MX240 Craft Interface Overview | 38
Preventing Electrostatic Discharge Damage to an MX240 Router | 467
Figure 101 on page
311):
311